S-type tubular turbine


Available in versions:
Kaplan.
Head:
from 4m to 20m.
Rotor diameter:
from 530mm to 1640mm.
Power:
up to 2500kW.

This modern turbine is characterized by high efficiency in a broad band of flow rates. In the double Kaplan regulation version of the turbine, the range of flow rate regulation extends from 20% to 100% of the rated discharge rate. The turbine controls act as an emergency water flow shutoff in the case of incidents such as a voltage drop in the electrical system. The control mechanism comes equipped with a safety system to prevent damage to the turbine.

The rotor blades are made of stainless steel and the control blades are made of ductile iron. The components of the regulation mechanism are made of stainless steel. The standard configuration includes mechanical face seals, hydraulic control system along with a hydraulic accumulator, temperature sensors for all bearings, linear potentiometers for measuring the attack angle of the rotor and controls, sensor for measuring turbine revolutions, flat belt or gear transmission.


Radial inlet turbine


Available in versions:
Kaplan.
Head:
from 2m to 20m.
Rotor diameter:
from 530mm to 2140mm.
Power:
up to 250kW.

This is a classic technical solution, which is being used successfully in many power plants. Thanks to the use of modern materials and technologies, this type of turbine enjoys a very strong level of interest.

The rotor blades are made of stainless steel, and the control blades are of ductile iron. The rotor hub is made of ductile iron. The components of the regulation mechanism are made of stainless steel. The standard configuration includes hydraulic control system along with a hydraulic accumulator, temperature sensors for all bearings, linear potentiometers for measuring the attack angle of the rotor and controls, sensor for measuring turbine revolutions, flat belt transmission.


Horizontal turbine


Available in versions:
Kaplan.
Head:
from 1,5m to 6m.
Rotor diameter:
from 830mm to 1870mm.
Power:
up to 600kW.

This modern turbine with its direct axial water flow is characterized by its higher efficiency when compared to more classic solutions. By making use of technological advances, it allows greater flow rates through the turbine compared to other turbines of the same rotor diameter. It is recommended for use in newly constructed power plants.

The rotor blades are made of stainless steel and the control blades and rotor hub are made of ductile iron. The components of the regulation mechanism are made of stainless steel. The standard configuration includes mechanical face seals, hydraulic control system along with a hydraulic accumulator, temperature sensors for all bearings, linear potentiometers for measuring the attack angle of the rotor and controls, sensor for measuring turbine revolutions, flat belt transmission.

We offer the following products:

  • Kaplan type S turbines
  • Kaplan type Z turbines
  • Kaplan horizontal turbine
  • Kaplan turbine with radial inlet
  • Kaplan type PIT turbines
  • Electrical equipment and automation
  • Power hydraulics
  • Hydroelectric plant monitoring accessible over the Internet or by SMS
  • Assembly and start-up
  • Warranty and Post-warranty service
  • Additional Equipment (lattices, bridges, latches)

Backed by our many years of experience, we offer assistance in developing the construction plans for small hydropower plants including adaptation of our turbines to meet the necessary criteria.

Depending on the projects’ requirements, we make possible a broad selection of technical solutions. Videos showing the construction of our hydro turbines: